Basically I'm in the process of modding my Brawlstick and was wondering about button holes...
I've decided to have 6 buttons on the top and was wondering if simply putting laminated artwork over the two empty holes would be enough to disguise them and be strong enough to keep from dipping in and becoming visible over time? I know there are those snap in button hole covers, but from what I can imagine they would show through the art even more, as they're not flush with the plate.
Any ideas for a solid solution to this problem?
Also I'm considering putting two buttons on the right side of the case, does anyone have experience of doing this with my type of stick? Maybe some tips as to what tools to use for a clean job etc? There should be enough space inside as removing the '4' and '8' button from the top of the stick leaves a tidy gap for them to go in from the side.
Any advice on either of these queries would be awesome.
Cheers!
I've decided to have 6 buttons on the top and was wondering if simply putting laminated artwork over the two empty holes would be enough to disguise them and be strong enough to keep from dipping in and becoming visible over time? I know there are those snap in button hole covers, but from what I can imagine they would show through the art even more, as they're not flush with the plate.
Any ideas for a solid solution to this problem?
Also I'm considering putting two buttons on the right side of the case, does anyone have experience of doing this with my type of stick? Maybe some tips as to what tools to use for a clean job etc? There should be enough space inside as removing the '4' and '8' button from the top of the stick leaves a tidy gap for them to go in from the side.
Any advice on either of these queries would be awesome.
Cheers!