Hi months ago I was customizing my brand new te2 fight stick, in doing so one of the switches came apart and the tiny ball bearing inside the sanwa switch fell into my pcb housing. After staying up all night photoshopping my artwork and swapping parts on my fight stick and putting on brand new buttons I completely forgot about it. I plugged it in and nothing. I know that the bearing could have shorted the board, but I removed it and noticed that one of the wires was loose and it broke off while examining it. Then I removed them all and in disgust have not touched it since then. I have decided to try to put it back together and see if it will work but I did not write down the wiring sequence. If someone could please send me a pic or the wiring order from cn1 or vbus markings on the board I would be so very gateful. Thank you in advance for any help you can provide Please help! A simple y,b,g,by from any of the stamped board markings would be great. Also if the board is shorted any tips on where to start looking / testing? I have decided to pad hack an old controller but I really want to get this thing back up and running. If nothing else i'll put in a pad hacked pcb perhaps.
↧