Hey guys hopefully you guys can help me with this issue that has been driving me a little nuts.
A while ago about a month ago I did a padhack with the madcatz 4716 pad for Xbox. Everything worked fine for about a month then it disconnected randomly and got stuck on an input for the majority of the day at a tournament lol.
I figured it was just the USB cable as there was an exposed cut on the USB cable. So I changed it. Same issue still occurred so I said okay maybe its a short or some bad wiring in the USB cable of the pad since I put this in a soul calibur te ps3 stick along side a imp so its dual moded. Same issue still occurs. It disconnects randomly and sometimes has all 4 LEDs blinking just sort of flashing. I'm gone on ideas I checked every connection so I figure its the PCB but then again it could be something else. If you have any ideas I'll be willing to try anything.
Worst case scenario however it's the PCB and I can easily obtain a new one. I did only buy the PCB at a local donation center for $3 so the loss of switching a PCB isn't that much. I'm just curious about what this issue occurs as its the first time this has happened via padhacking in my expierence
A while ago about a month ago I did a padhack with the madcatz 4716 pad for Xbox. Everything worked fine for about a month then it disconnected randomly and got stuck on an input for the majority of the day at a tournament lol.
I figured it was just the USB cable as there was an exposed cut on the USB cable. So I changed it. Same issue still occurred so I said okay maybe its a short or some bad wiring in the USB cable of the pad since I put this in a soul calibur te ps3 stick along side a imp so its dual moded. Same issue still occurs. It disconnects randomly and sometimes has all 4 LEDs blinking just sort of flashing. I'm gone on ideas I checked every connection so I figure its the PCB but then again it could be something else. If you have any ideas I'll be willing to try anything.
Worst case scenario however it's the PCB and I can easily obtain a new one. I did only buy the PCB at a local donation center for $3 so the loss of switching a PCB isn't that much. I'm just curious about what this issue occurs as its the first time this has happened via padhacking in my expierence