So, I just got a cerberus for dual modding a 360 MLG TE and tried installing it today. After getting the usb wires and pcb in place, I connected to a pc and did the testing as recommended. At first, the cerberus showed up fine and work (with reverse LP/MP/HP and LK/MK/HK) in skullgirls (steam). However, I couldn't get the 360 mode to work. So, then I plugged it into a ps3 and tried skullgirls (ps3) again, this time LP/MP/HP and LK/MK/HK worked fine, no wires touched from before. However, at this point I noticed start/select did not work. Last, I tried plugging the stick into a 360 for testing skullgirls (360) yet again (my friend really loves SG) and the stick did not show up at all.
I should note that at this point all four player indicator lights were simultaneously lit solid, no flashing. I was under the impression that at least ps3 mode would show my player indicator correctly, so this seemed odd to me.
After this, I took the PCB out, tried re-seating all of the wires again, then plopped the pcb back in. This time, nothing showed up on any system.
Later, I tried taking some wires I had that had cables with soldered tips, I figured the connection would be better and I could just twist the leads to see if the pcb was working. So, I inserted the wires w/ soldered tips into the terminals and twisted the other ends with the usb wire. Again, no good. I'm getting a bit frustrated so I'm calling it good for today.
I'll post some pictures up, but I don't know why this isn't working. I don't know for sure, but suppose if I shorted one of the pcbs with one of those copper strands, would either/both pcb be shorted and dead? Or would there be no damage after a short? Double-checked the pins, all of them are straight and I'm confident that I pressed the cerberus down on the 360 pcb pretty firmly. Also, I have a multimeter, any things I should test?
http://imgur.com/a/NZzbY
The usb wires in the first picture are for the X360-IN terminals and the third picture are for the USB OUT terminals.
I should note that at this point all four player indicator lights were simultaneously lit solid, no flashing. I was under the impression that at least ps3 mode would show my player indicator correctly, so this seemed odd to me.
After this, I took the PCB out, tried re-seating all of the wires again, then plopped the pcb back in. This time, nothing showed up on any system.
Later, I tried taking some wires I had that had cables with soldered tips, I figured the connection would be better and I could just twist the leads to see if the pcb was working. So, I inserted the wires w/ soldered tips into the terminals and twisted the other ends with the usb wire. Again, no good. I'm getting a bit frustrated so I'm calling it good for today.
I'll post some pictures up, but I don't know why this isn't working. I don't know for sure, but suppose if I shorted one of the pcbs with one of those copper strands, would either/both pcb be shorted and dead? Or would there be no damage after a short? Double-checked the pins, all of them are straight and I'm confident that I pressed the cerberus down on the 360 pcb pretty firmly. Also, I have a multimeter, any things I should test?
http://imgur.com/a/NZzbY
The usb wires in the first picture are for the X360-IN terminals and the third picture are for the USB OUT terminals.