Hello,
I've recently ordered a PS360+ from focusattack.com and it arrived today. Of course I immediately installed the pcb into my stick (custom) and tried it out.
The stick gets recognized normally by PS3 and functions as expected so I assume I connected everything correctly. When I connect the stick to the console the leds on the pcb are constantly on.
Unfortunately I can't say the same about xbox360. When I connect it to one of those (tested on 2 xboxes) the leds start flashing, and no inputs are registered by the console at all.
I tried using a shorter USB cable but wasn't successful. I also tried holding start and/or select while plugging the stick in in hopes of somehow switching modes but that also didn't work. My next guess would be to upgrade the firmware but I would assume that a new build would come with pre installed firmware that at least supported ps3 and 360.
Does anyone else have any suggestions for troubleshooting?
I've recently ordered a PS360+ from focusattack.com and it arrived today. Of course I immediately installed the pcb into my stick (custom) and tried it out.
The stick gets recognized normally by PS3 and functions as expected so I assume I connected everything correctly. When I connect the stick to the console the leds on the pcb are constantly on.
Unfortunately I can't say the same about xbox360. When I connect it to one of those (tested on 2 xboxes) the leds start flashing, and no inputs are registered by the console at all.
I tried using a shorter USB cable but wasn't successful. I also tried holding start and/or select while plugging the stick in in hopes of somehow switching modes but that also didn't work. My next guess would be to upgrade the firmware but I would assume that a new build would come with pre installed firmware that at least supported ps3 and 360.
Does anyone else have any suggestions for troubleshooting?