Hi, i'm trying to figure out a properly way to make a professional arcade stick for my AES system. I mean, i have Sanwa/Seimitsu arcade parts and a arcade stick case to mount them, my doubt is which pcb would be the best to install.
I own the Tototek's ps2 to Neo converter and it's great but all the ps2 pads that i have tried had problems from the wire, they break inside and it causes malfunction, the inputs gets crazy in 2 or 3 months. I know how to roll the wires properly, this happends because these joypads are cheap, their pcb are good for soldering though. I use these cause i don't have skills to solder/hack a original Dual Shock pad.
I was thinking if the Neogeocd pad would be the best solution, however i don't know if it's possible because the D-pad on that one is different from the regular conductive rubbers out there, there are switches soldered on the pcb for the D-pad.
Anyone had same experience?
I own the Tototek's ps2 to Neo converter and it's great but all the ps2 pads that i have tried had problems from the wire, they break inside and it causes malfunction, the inputs gets crazy in 2 or 3 months. I know how to roll the wires properly, this happends because these joypads are cheap, their pcb are good for soldering though. I use these cause i don't have skills to solder/hack a original Dual Shock pad.
I was thinking if the Neogeocd pad would be the best solution, however i don't know if it's possible because the D-pad on that one is different from the regular conductive rubbers out there, there are switches soldered on the pcb for the D-pad.
Anyone had same experience?